KIT 56

 Return to the BUILD


“In this phase you will position the floor mats on the floor of your Eleanor Mustang model.

 

Contents


Parts

Build


Front and Rear Floor Mats

Step 56.1

Retrieve your Interior assembly from the previous kit. Press the four pins of the Driver Front Mat into the matching holes at this location of the Front Floor, as shown.

My Floor Mats arrived a bit warped. I let them soak in warm water for a few minutes, then gently flexed them back into a flat shape:

Look closely at the pins of the mat and the holes in the floor. They are different sizes, so this will only fit one way:

Step 56.2

Press the four pins of the Front Passenger Front Mat into the matching holes at this location of the Front Floor, as shown:

Step 56.3

Press the two pins of the Rear Passenger Floor Mat 1 into the matching holes at this location of the Rear Floor, as shown.

Again, look closely at the pins of the mat and the holes in the floor. They are different sizes, so this will only fit one way:

Step 56.4

Press the two pins of the Rear Passenger Floor Mat 2 into the matching holes at this location of the Rear Floor, as shown:

Thoughts


These rubber Floor Mats are a nice touch and blend into the interior quite nicely! I struggled a bit to get the pins of the mats to fully seat in the holes, but I managed to get them into place. It might have been easier to install these mats before the seats went in.

Next Up


 Kit 57 – Rear Seat Base

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.