Return to the BUILD

“In this phase you will fix the upper left rear trim panel on top of the lower left rear trim panel of your Eleanor Mustang model.“

Contents

Parts

Build

Upper Left Rear Trim Panel

Step 60.1

Fit the two posts of the Ventilation Grille into the matching holes of the Upper Left Rear Trim Panel, aligning it into the recess as shown:

Step 60.2

Secure this Grille into place from the other side with two (2) PS05 screws:

Step 60.3

Retrieve your Interior assembly from the previous kit. Fit this Upper Left Rear Trim Panel to the top edge of the Lower Left Rear Trim Panel, aligning the three mounting tabs to the relevant posts as shown.

As I mentioned in the last Kit, I decided to wait until these two sections were connected before attaching them to the Interior:

Step 60.4

Begin securing these Left Rear Trim Panels together with two (2) PS05 screws at the rear mounting tabs:

Step 60.5

Finish securing these Left Rear Trim Panels together with one (1) PS14 screw at the forward tab:

Retrieve your Interior assembly from the previous kit and carefully turn it upside down. Fit this Rear Trim Panel to the left rear corner of the Interior, aligning the three mounting tabs to the relevant posts as shown:

Note how the rear corner slides under edge of the Rear Luggage Platform:

And at the front, there is a tab with a hole that needs to be pressed down onto this pin of the Rear Floor:

Finally, secure the Trim Panel to the Interior with three (3) PS05 screws.

These PS05 screws were supplied with the previous kit:

Thoughts

I completed these last two kits slightly differently from the instructions, but I feel connecting these two Trim Panels together before attaching them to the Interior put less stress on the mounting points.

Next Up

 Kit 61 – Trunk Partition Panel