KIT 92

 Return to the BUILD


“In this phase, you will install the upper and lower air scoops onto both sides of the main body shell. Then you will fit the gas cap of your Eleanor Mustang.

 

Contents


Parts

Build


Air Scoops and Gas Cap

NOTE: I slightly changed the order of these steps from the magazine to make the process easier.

Step 92.1

Retrieve your Body assembly from the previous kit. Fit the Lower Right Side Air Scoop to this location of the Body, as shown:

Step 92.2

Secure this Air Scoop into place from the inside with one (1) PS05 screw:

Step 92.3

Fit the two posts of the Upper Right Side Air Scoop to the matching holes at this location of the Body, as shown:

Step 92.4

Secure this Air Scoop into place from the inside with two (2) PS05 screws:

Step 92.5

Turn your Body assembly around and fit the Lower Left Side Air Scoop and Upper Left Side Air Scoop to the Body in the same way:

Step 92.6

Secure the Lower Air Scoop into place from the inside with one (1) PS05 screw:

Steps 92.7

Secure the Upper Air Scoop into place from the inside with two (2) more PS05 screws:

Step 92.8

Fit the post and pin of the Gas Cap Base into the matching holes at this location on the left side rear of the Body, as shown:

Step 92.9

Secure the Cap Base into place from the inside with one (1) PS05 screw:

Step 92.10

Slide the pins of the Gas Cap into between these tabs of the Gas Cap Base until they pop into the matching holes, as shown:

Thoughts


It was a bit surprising to me to see how much these aggressive Air Scoops change the look of our Eleanor. It is getting better every kit!

Next Up


 Kit 93 – Hood Hinges/Springs/Guides/Brackets

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.